INSTRUCTIONS-NISSAN-VQ ENGINE GROMMET

Here is a DIY Instructions on how to replace the OEM seals on your Nissan VQ engine.

1- THIS IS A SIMPLE HOLE SAW (SIZE 2 INCH) THAT YOU CAN BUY FROM MOST HARDWARE STORE.

(WE GOT OURS FROM ACE HARDWARE AND IT WAS $7.)

2- THIS IS HOW YOUR VALVE COVER LOOKS WHEN YOU TAKE IT OFF OF YOUR ENGINE

NOTE PICTURE SHOWN MOST LEFT SPARK PLUG HOLE DRILLED.

3- WARNING LEASE DO NOT REMOVE BAFFLE PLATE WARNING.

4- POSITION THE HOLE-SAW CONCENTRIC TO SPARKPLUG HOLE AND DRILL BAFFLE PLATE

SLOWLY AND CAREFULLY.

5- YOU WILL ONLY NEED TO DRILL JUST ENOUGH TO DRILL THROUGH THE BAFFLE PLATE

(WE CLEANED UP ALL THE DEBRIS TO SHOW YOU CLEAR PICTURE DRILL ALL 6 POSITIONS AND CLEAN OFF DEBRIS WHEN DONE. )

6- NOW YOU WILL BE ABLE TO POP OUT THE OLD O-RING GROMMET OUT OF THE VALVE

COVER. PLEASE REPEAT 6 TIMES.

7- THIS IS WHAT IT WOULD LOOK LIKE WITH THE O-RING GROMMET OUT

8- USE BLACK RTV SILICONE ON TOP SIDE OF THE NEW O-RING GROMMET

(WE USED CLEAR ON OUR DEMO PICTURE SO YOU CAN SEE BETTER)

9- PLACE THE NEW O-RING GASKET IN TO THE HOLE. NOW YOU ARE READY TO RE-INSTALL

YOUR VALVE COVER GASKET TO YOUR ENGINE.

Copyright 2014 R&D Factory All rights reserved.